Panopto: Basic Editing


Editing Basics with Panopto

To begin editing your recordings, first you must access the LSU Panopto Web Portal, either via Moodle or directly from the LSU Panopto Web Portal login page.

NOTE: Silverlight is required for editing, and multiple video cards may crash silverlight. Editing does not affect the original session content.

1. Log in to the LSU Panopto Web Portal via Moodle or directly from the LSU Panopto Web Portal login page

2. Click the Everything button on the left side of the Panopto homepage. 

everything button in panopto


3. Click the Edit button under the video you wish to edit and view the following basic editing features.

edit video button in panopto


To Remove Beginning and End of a Recording:

1. Grab the handles on either ends of the timeline located at the bottom and drag inward to the desired time you want the recording to begin/end.

NOTEEliminated portions are grayed out. and the center section is kept.

cropping a video in panopto


To Remove the Middle Portions of a Recording Audio and/or Video:

1. Click once on the scissors icon.

2. Click on the section of the presentation to remove. NOTE: The click that comes first will set the start point of the cut and the second click sets the end point of the cut. Drag handles in either direction if needed to adjust segment. The area in the shaded yellow area in the picture below shows the starting and ending point of this action. 

dragging to crop a video
 

3. Click Publish or Revert near the top of the page.

NOTE: Publishing saves all changes, reverting reverts the video back to the original.

publish and revert buttons in panopto
 

**For Advanced Editor with Panopto, see: Panopto: Advanced Editing.
 

Referenced from: Panopto Support

17454
11/8/2023 1:55:29 PM